What are the safe operating procedures for CNC boring machines?

What are the specific contents of the safety operation regulations of CNC boring machine? What needs to be complied with? Now, we will introduce its safety operating procedures in order to have a better understanding of the CNC boring machine. The safe operating procedures for CNC boring machines are as follows: (1) Observe the general safe operating procedures for milling and boring workers. Wear labor protection products as required. (2) Check whether the connection of the operating handle, switch, knob, clamp mechanism, and hydraulic piston is in the correct position, whether the operation is flexible, and whether the safety device is complete and reliable. (3) Check whether there are obstacles in the effective operating range of each axis of the machine tool. (4) It is strictly forbidden to use the machine tool with super performance. Select the cutting speed and feed rate according to the material of the workpiece. (5) When loading and unloading heavier workpieces, reasonable hoisting tools and lifting methods must be selected according to the weight and shape of the workpiece. (6) When the spindle is rotating and moving, it is strictly prohibited to touch the spindle and the tools installed at the end of the spindle. (7) When changing the tool, the machine must be stopped first and can be replaced after confirmation. When changing, pay attention to the damage of the blade. (8) It is forbidden to step on the rail surface and painted surface of the equipment or place objects on it. It is strictly forbidden to knock or straighten the workpiece on the workbench. (9) After inputting the processing program for the new workpiece, the correctness of the program must be checked, whether the simulated running program is correct, and automatic cycle operation is not allowed without testing to prevent the machine from malfunctioning. (10) When using the flat-rotation radial tool post for independent cutting, first return the boring bar to the zero position, and then use M43 to change to the flat-rotation mode in the MDA mode. If the U-axis needs to move, you must ensure that the U-axis is manually moved. The clamping device has been released. (11) When the worktable needs to be rotated during work, it should be ensured that it does not touch other parts of the machine tool or other objects around the machine tool during rotation. (12) When the machine tool is running, it is forbidden to touch the rotating silk shaft, polished rod, main shaft, and pan disk, and the operator is not allowed to stay on the moving parts of the machine tool. (13) When the machine tool is running, the operator is not allowed to leave the work post or be supervised by someone. (14) If there are abnormal phenomena and noises during the operation of the machine tool, stop the machine immediately, find out the cause, and deal with it in time. (15) When the headstock of the machine tool and the worktable are at or near the limit of motion, the operator is not allowed to enter the following areas: a. Between the bottom surface of the headstock and the bed; b. Between the boring shaft and the work; c. Extension of the boring shaft Between the machine bed or the work surface; d. between the worktable and the spindle box when the worktable is moving; e. between the rear tail tube and the wall and the fuel tank when the boring shaft rotates; f. between the worktable and the front main column Between; g. Other areas that may cause squeezing. (16) When the machine tool is shut down, the worktable must be retracted to the middle position, the boring bar must be retracted, then the operating system must be exited, and the power supply must be cut off. Unless specified, the article is the original text of Tiecheng Machinery CNC Machining Center, welcome to reprint! Please indicate the address of this article for reprinting, thank you. Article source: http://www.wxdtc.com/