Do you know that precision parts manufacturers need to pay attention to processing

u200bPrecision parts manufacturers attach great importance to the processing and surface treatment of parts, so the operation process is also relatively strict. Surface treatment can extend the life of the product and improve the quality. Since the surface of the parts needs to be polished, this can not only be affected by the process and polishing equipment, but the polishing itself will be affected by the material, so the technology to improve the surface performance of the parts needs to be upgraded, but more important For hardened film deposition, and nitriding, carburizing technology. Precision parts manufacturers explain processing pay attention to check whether the moving parts are filled with lubricating oil before mechanical work, then start and check whether the clutch and brake are normal, and run the machine idling for 1-3 minutes. Operation is strictly prohibited when the machine is faulty. Maintain the correct posture at work and have sufficient energy to cope with the work. If you find that you are unwell, you must leave the job immediately and report it to the leader. When operating, you must concentrate your thoughts, chat and cooperate with each other. The operator should not operate in a state of irritability and fatigue, so as to avoid accidents and ensure safe operation. Before entering the work position, all employees check whether their clothing meets the job requirements. Slippers, high heels and clothing that affect safety are not allowed, and those with long hair must wear a helmet. When changing the mold, turn off the power first, and then start to install and debug the mold after the press movement department stops running. After installation and adjustment, move the flywheel by hand to test punch twice to check whether the upper and lower molds are symmetrical and reasonable, whether the screws are firm, and whether the blank holder is in a reasonable position. Wait for all other personnel to leave the working area of u200bu200bthe machine and remove the debris on the workbench before turning on the power to start the machine. Surface treatment of precision parts manufacturers: because the nitriding technology can obtain a high level of surface performance, and the nitriding technology has a very high consistency with the quenching process of the steel in the precision parts, and the nitriding temperature is very low Yes, after the nitriding technology is processed, there is no need for an intense cooling process, so the deformation of the precision parts will be very small, so the nitriding technology is also used to strengthen the surface performance when the precision parts are processed. The earliest technology is used One of the most widely used.