Do you know the code of planer processing technology?

The planer processing technology code is an important content of its processing technology, and it is also the basis and standard of its processing. What does it specifically include? For this reason, the editor has found some information from the Internet and introduced it to everyone after sorting and summarizing, so that users can master this aspect well and add some professional knowledge. If there are any incomplete introductions, please understand. 1. It is required that planer workers should be trained on quality, safety, professional technical knowledge and related quality system documents, so that planer tools should be equipped with corresponding capabilities. 2. Equipment and tools Equipment and tools include planer, planer, vise, height plate, steel ruler, depth ruler, steel ruler, wrench, vernier caliper, file, etc. 3. Preparations (1) Very familiar with drawings and process requirements, understand process requirements and process. (2) Various planing knives should be prepared, and the planing amount should be selected reasonably. 4. Clamping of the workpiece (1) The flat-nose pliers are in the correct position on the workbench, and the dial indicator can be used for alignment if necessary. (2) Parallel shim should be placed under the workpiece, and the thickness should be appropriate. The workpiece should be tightly leaned on the parallel shim when clamped. (3) If the two ends of the workpiece are higher or protruding from the jaws, pay attention to the higher or less protruding amount, so as not to affect the reliability of the workpiece clamping. (4) When multiple marking blanks are processed at the same time, they must be aligned according to the processing line of each piece and be on the same plane. (5) If the planer workbench is to clamp higher workpieces, auxiliary supports should be added to consolidate the reliability of the clamping. (6) When processing heavy and narrow workpieces on a gantry planer, and the processing needs to be focused on one side, the workpieces should be processed at the same time or weighted as much as possible. (7) After the workpiece is clamped, use jog to drive, and at the same time check whether there is any friction in each part, if not, calibrate the stroke length. 5. When clamping the planer, the protruding length of the tool should be as short as possible, and the tool should not touch the protruding part of the workpiece. 6. Planing processing (1) Multi-knife planing should be used as far as possible on the gantry planer. (2) Thin plate workpieces should be turned over and clamped several times according to the margin situation to reduce the degree of deformation of the workpiece. (3) The cutting speed should be reduced when planing the surface with empty sipes, and the tool stroke should be controlled well. (4) During fine planing, if there are ripples or abnormal sounds on the surface of the workpiece, stop and check immediately. 7. Self-inspection planing parts are checked according to the drawing, whether they meet the drawing requirements, and whether the deviation is within the allowable range. In addition, check the machined parts, mainly to see if there are burrs, if any, they should be cleaned up. (Picture/text http://www.wxdtc.com/)