Processing tips in mechanical processing plants

The mechanical processing procedure of the mechanical processing plant is one of the technical documents of the processing process and operation methods. It is a process document written in a more reasonable process and operation method in accordance with the rules and approved under specific production conditions. Later used to teach production.




Remove the jaws of the vise during processing in the mechanical processing factory, and process two M4 threaded holes, and use aluminum static rivets to rivet two steel plates with a thickness of 1.5mm, which are flush with the jaws, with a thickness of 0.8mm. The hard brass plate is fastened to the jaws with M4 static screws to form a durable soft jaw. This can also protect the parts from being clamped, and is interchangeable.





It is inconvenient to use magnets to draw small parts on the top of machining. You can suck an iron plate under the magnet. Not only can you attract many small parts, but also the small parts will be automatically poured into the collection when the iron plate is opened. Inside the box. When the pulley is driven in mechanical processing, the pulley often slips between the pulley and the axle. Use a 15~18mm dimple drill to cut the series of sockets on the axle to form an adsorption force to prevent slipping.





In the machining process of the mechanical processing plant, when the handle of the Allen wrench is short and cannot be applied, the pipe with a slightly larger inner diameter than the wrench can be milled from a section, and the wrench can be pierced into the groove, which can be used as a long handle. There will be a lot of workpieces that are not produced at once, but when the workpiece is produced. It is just a rough model. If the factory becomes a real product, it will rely on some mechanical equipment. Carry out mechanical processing, according to different product requirements for mechanical processing.